2026.9.2
Home ▸ Integrations

AquaLogic

The AquaLogic integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] provides connectivity to a Hayward/Goldline AquaLogic/ProLogic pool controller. Note that an RS-485 to Ethernet adapter connected to the pool controller is required.

Configuration

To add the AquaLogic hub to your Home Assistant instance, use this My button:

Manual configuration steps

If the above My button doesn’t work, you can also perform the following steps manually:

  • Browse to your Home Assistant instance.

  • Go to Settings > Devices & services.

  • In the bottom right corner, select the Add Integration button.

  • From the list, select AquaLogic.

  • Follow the instructions on screen to complete the setup.

Configuration parameters

Host

Hostname or IP address of your AquaLogic controller. For example, 192. 168.1.50.

Port

TCP port used to connect to the AquaLogic controller. For example, 8899.

Supported functionality

Sensors

The AquaLogic integration provides the following sensors.

Note

Not all AquaLogic controllers/setups provide data to all sensors.

  • Air Temperature
    • Description: The air temperature.
  • Pool Temperature
    • Description: The pool temperature.
  • Spa Temperature
    • Description: The spa temperature.
  • Pool Chlorinator
    • Description: The pool chlorinator setting.
  • Spa Chlorinator
    • Description: The spa chlorinator setting.
  • Salt Level
    • Description: The current salt level.
  • Pump Speed
    • Description: The current pump speed (Hayward VS pumps only).
  • Pump Power
    • Description: The current pump power usage (Hayward VS pumps only).
  • Status
    • Description: The current system status.

Switches

The AquaLogic integration provides the following switches.

Note

Not all AquaLogic controllers/setups use/support all switches.

  • Filter
    • Description: Controls the filter pump.
  • Filter Low Speed
    • Description: Controls low speed mode on the filter pump (multi-speed pumps only).
  • Lights
    • Description: Controls the Lights relay.
  • Aux 1
    • Description: Controls the Aux 1 relay.
  • Aux 2
    • Description: Controls the Aux 2 relay.
  • Aux 3
    • Description: Controls the Aux 3 relay.
  • Aux 4
    • Description: Controls the Aux 4 relay.
  • Aux 5
    • Description: Controls the Aux 5 relay.
  • Aux 6
    • Description: Controls the Aux 6 relay.
  • Aux 7
    • Description: Controls the Aux 7 relay.

Removing the integration

This integration follows standard integration removal.

To remove an integration instance from Home Assistant

  1. Go to Settings > Devices & services and select the integration card.
  2. From the list of devices, select the integration instance you want to remove.
  3. Next to the entry, select the three dots menu. Then, select Delete.