AirPatrol
The Airpatrol integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] allows you to control air conditioning units through Airpatrol
Prerequisites
Your Airpatrol WiFi unit must be configured via the native Airpatrol application prior to being useable with this integration. This includes setting up the Wi-Fi connection and any initial device configuration.
Configuration
To add the AirPatrol device to your Home Assistant instance, use this My button:
If the above My button doesn’t work, you can also perform the following steps manually:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the
Add Integration button. -
From the list, select AirPatrol.
-
Follow the instructions on screen to complete the setup.
Supported functionality
Climate
The integration will create a climate entity for each air conditioning system found. The climate entity allows you to control:
- HVAC mode: Set the operation mode, such as off, heat, and cool.
- Target temperature: Set the desired temperature for heating or cooling.
- Fan mode: Control the fan speed (if supported by your system).
Sensors
The integration will create the following sensors for each air conditioning system found:
- Temperature: Shows the current temperature (°C) in the room.
- Humidity: Shows the current humidity in the room.
Known limitations
Some features may not be available depending on your specific Airpatrol model and firmware version. Check the Airpatrol documentation for your specific device to understand available features. This integration has only been tested with Airpatrol WiFi v5.
Removing the integration
This integration follows standard integration removal, no extra steps are required.
To remove an integration instance from Home Assistant
- Go to Settings > Devices & services and select the integration card.
- From the list of devices, select the integration instance you want to remove.
- Next to the entry, select the three dots
menu. Then, select Delete.