TechnoVE
The TechnoVE integration provides connectivity with TechnoVE Smart Charging Station through the station local API.
Configuration
To add the TechnoVE device to your Home Assistant instance, use this My button:
TechnoVE can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.
If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the
Add Integration button. -
From the list, select TechnoVE.
-
Follow the instructions on screen to complete the setup.
Binary sensors
The integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] adds the following binary sensors:
- Battery protected - On / Off
- Charging - Charging / Not charging
- Conflict with power sharing mode - On / Off
- Power sharing mode - On / Off
- Static IP - Connected / Not Connected
- Update - Up-to-date / Update available
Sensors
The integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] adds the following sensors:
- Input voltage
- Output voltage
- Max station current
- Current
- Total energy usage
- Last session energy usage
- Wi-Fi signal strength
- Wi-Fi network name
- Status
Switch
The integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] adds the following switch:
| Name | Description |
|---|---|
| Auto-charge mode | When enabled, vehicles will start charging automatically when plugged in. When turned off, charging will need to be manually started each time a vehicle is plugged in. Note: Disabling auto-charge mode does not interrupt an ongoing charging session. |