PrusaLink
The PrusaLink integration allows you to monitor your Prusa 3D printer and its progress with your Home Assistant installation. This integration works with Prusa MINI and Prusa MK4. This integration requires PrusaLink v2. If you have the Prusa MINI, you need to run firmware 4.4.0 or later.
When adding the integration, you will be asked to provide a hostA device that participates in your network. If asked for the host, enter either the device’s IP address or host name. If you don’t know those, check the list of hosts in your router.
[Learn more] and an API key. These are the credentials you set up when setting up PrusaLink on your printer.
To obtain the host name and API key/password:
- On your printer, navigate to Settings > Network > PrusaLink.
- Find the device’s IP address. Alternatively, you can look for the printer’s IP address or hostname on your router.
- Depending on your model, the entry may not be called API key, but Password.
Configuration
To add the PrusaLink integration to your Home Assistant instance, use this My button:
PrusaLink can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.
If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the Add Integration button.
-
From the list, select PrusaLink.
-
Follow the instructions on screen to complete the setup.