Nexia/American Standard/Trane

The nexia integration allows you to integrate your Nexia (Trane) thermostats or American Standard thermostats into Home Assistant.

There is currently support for the following device types within Home Assistant:

• Binary sensor
• Climate
• Sensor
• Scene
• Switch

Configuration

To add the Nexia/American Standard/Trane integration to your Home Assistant instance, use this My button:

Nexia/American Standard/Trane can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.

Binary sensor

The following binary sensors are added for each thermostat:

• Blower Active

Sensor

The following sensors are added for each thermostat:

• Air Cleaner Mode
• Current Compressor Speed
• Requested Compressor Speed
• Outdoor Temperature
• Relative Humidity
• System Status

The following sensors are added for each thermostat zone:

• Zone Temperature
• Zone Setpoint Status
• Zone Status

Climate

The climate platform lets you control a thermostat.

The following Trane thermostats are supported: XL1050, XL850, XL824

The following American Standard thermostats have been reported to work: AZONE1050, AZONE850, ACONT824

The following thermostats are not supported: XL624, XL950, AZONE950, AZEMT500, AZEMT400B

Other thermostats may work, but they have not been tested.

Number

The number platform lets you adjust the fan speed on systems with variable-speed fan support.

Scene

The scene platform lets you activate a nexia automation.

Switch

The switch platform lets you enable or disable hold mode for each thermostat.

Service nexia.set_aircleaner_mode

Sets the air cleaner mode. Options include ‘auto’, ‘quick’, and ‘allergy’. This setting will affect all zones on the same thermostat.

Service nexia.set_humidify_setpoint

Sets the humidify setpoint. This setting will affect all zones on the same thermostat.