knx integration must be configured correctly to use this integration, see KNX Integration.
knx cover platform is used as an interface to KNX covers.
To use your KNX covers in your installation, add the following to your
# Example configuration.yaml entry cover: - platform: knx name: "Kitchen.Shutter" move_long_address: '3/0/0' move_short_address: '3/0/1' position_address: '3/0/3' position_state_address: '3/0/2' travelling_time_down: 51 travelling_time_up: 61
KNX group address for moving the cover short time up or down. If the KNX device has a stop group address you can use that here.
Separate KNX group address for requesting the current position of the cover.
Separate KNX group address for requesting the current angle of cover.
Time cover needs to travel down in seconds. Needed to calculate the intermediate positions of cover while traveling.
Time cover needs to travel up in seconds. Needed to calculate the intermediate positions of cover while traveling.
Set this to true if your actuator report fully closed as 100%.